HO Scale Locomotive Module with Sound
The LM-2S is a module that you can install into a model train locomotive so the
locomotive can be controlled and setup by a Ring Engineering RailPro Controller,
such as the HC-2 Handheld Controller with a Color Touch Screen! After the LM-2S
is installed in a locomotive, you will be able to control the locomotive speed,
direction, up to 6 light outputs and sounds! The LM-2S has “Direct Radio” (RF
transceiver) built inside. The built in RF module allows commands and data to be
sent and received to and from the module. You can load a picture of your choice
into the LM-2S module. Then you will be able to touch the screen of the HC-2 to take control of
your locomotive! You can even download new sounds and light effects using the
built in Direct Radio!
The LM-2S is electrically compatible with the DCC plug found in many locomotives
to promote easy installation. However, the LM-2 responds to RailPro Direct Radio
commands only and DOES NOT respond to DCC commands and can not be controlled or
setup with any DCC system.
|The LM-2S is
equipped with Direct Radio! This allows Ring Engineering Controlling Devices
such as the HC-2, Handheld Controller with Color Touch screen, to control
and configure your locomotive by sending and receiving data directly to the
LM-2S through the air by use of RF transmission! The Direct Radio is very
fast giving your locomotive quick response to your controls. Further, a
controlling device can detect your LM-2S with just a few touches on the
screen. Because of Direct Radio, you can load a picture of your locomotive
to the LM-2S! You can also load Sounds, Light Effects and much more!
Your LM-2S is equipped with
Rail Sonic HD Sound System! This is Ring Engineering's proprietary technology
that allows your LM-2S to produce realistic locomotive sounds!
Radio Load Sharing is a
truly an innovative invention from Ring Engineering. It allows
your locomotives that are linked together
(sometimes called Consisted
to actually share pulling power. Only RailPro equipped
locomotives use Direct Radio to talk to each other to be sure each
locomotive pulls its share of the load! Even more amazingly, Ring
Engineering's patent pending process only takes seconds to setup!
light outputs. Can be configured for multiple light effects on a
single output including On/Off, Dim, Ditch, Mars, Strobe, and more!
Additional light effects can be loaded using DirectRadio!
Built in protection with fault reporting by Direct Radio!
Tiny size 1.50 x 0.68 x 0.25 Inches for easy fit.
You will need a RailPro controller such as a HC-2 (Handheld
Controller with Color Touch Screen - Not Included) to control, setup and monitor
a LM-2S. Actual HC-2 screen shots are shown below!
Pages to Select and Control Locomotives
Pages to Setup Locomotives
Page to Monitor Locomotive
LM-2 Locomotive Module
WH-6 6 Pin Wiring Harness
US Patent 8,807,487 and 10,780,362
Made In USA
Not recommended for persons under the age of 14
Copyright © 2004-2015 Ring Engineering, Inc.